How to carry it out?
- Before continuing with the cleaning, it is advisable to remove all surface residue, such as dust, debris and coarse dirt, with a broom or vacuum cleaner.
- We recommend treating small areas at a time. The size of the area to be treated should be determined by the absorbency of the material.
- When applying on highly absorbent surfaces, such as terracotta, it is necessary to work on an area of no more than 4 to 5 square metres, to make sure the product does not penetrate the surface completely.
- When applying on surfaces with low absorbency, such as polished natural stone or ceramic tiles, the treated area can be larger, depending on the user's preference.
Application
Before applying the product, a preliminary test must be carried out on an unexposed surface or an unused piece of material to check the suitability of the product.
Application steps
1. The product can be used undiluted or diluted in clean water, depending on the amount of dirt to be removed:
- When used as the last step in the double wax stripping process, or when dissolving particularly stubborn resin, wax or polymers, the product must be diluted to 50%. When used on absorbent materials, such as cotto or concrete, the product can be used undiluted.
- When used for a heavy degreasing action to remove large amounts of stubborn residue, or for site cleaning on acid-sensitive materials, the product must be diluted to 20 to 30% in water (1 part product to 2-4 parts water).
- When used as a simple degreaser to clean a floor periodically, the product must be diluted to 10% (1 part product to 9 parts water).
2. Apply the product in the chosen dilution ratio to the surface, cover the entire surface to be cleaned completely and spread it evenly and vigorously with a single-disc machine or large brush.
3. Leave the product to act for about 10 to 15 minutes and assist the dissolving action by going over it with a single-disc machine or large brush at more or less regular intervals, depending on how difficult the residue is to remove.
This enhances the dissolving action of the product and gives you better results.
4. When applying on particularly absorbent surfaces, it may be necessary to pour a little more onto the surface while working with the product, to compensate for the product absorbed by the material.
For the best possible results, the surface must be completely covered with a fine layer of product during the treatment. This can be done with a more or less abrasive disc or brush, depending on the type of material.
5. Remove the residue once the stated time has passed. Pour enough clean water onto the surface to form an emulsion with the solution on the floor.
Spread this evenly with the single-disc machine or brush and then remove this emulsion.
This is best done with a wet vacuum, but alternatively the excess liquid can be absorbed with cloths or absorbent paper towels.
- When applying on surfaces with low absorbency, such as polished natural stone or ceramic tiles, the treated area can be larger, depending on the user's preference.
Application
Before applying the product, a preliminary test must be carried out on an unexposed surface or an unused piece of material to check the suitability of the product.
6. After removing the residue, rinse the surface thoroughly with clean water.
If the results are not fully satisfactory, repeat the process following the steps above.
When can the surface be used again?
After rinsing the surface with water, the floor can be used again as soon as it is dry.
When reapplying the treatment, you must wait until the surface is completely dry. The time this takes depends on the type of stone and the absorbency of the material.